Bell Boots - The right way to Use Them on Your Horses
Bell boots are a horse’s first line of defense in opposition to their own sharp back feet. They wrap across the front hoofs and cover the vulnerable coronary band and heel bulbs, which are crucial for stopping lacerations to those sensitive areas.
We regularly use bell boots when training our horses or for those prone to overreaching and injuring themselves. But not all horses want bell boots.
What’s the aim of bell boots for horses?
Bell boots are protective equipment that attaches to the horse’s entrance feet. The bell boot serves functions for equestrians: it protects their horses’ from injury and prevents their back feet from hitting the horseshoes on their front toes and pulling them off.
Once they run, some horses tend to overreach and strike the entrance of their rear hoofs into the back of their front feet. The soft areas at the heel bulb and coronary band are most vulnerable to injury from this hitting.
What do bell boots protect?
The widespread area damaged is the heel bulb, coronary band, and decrease pastern. Generally an overreach injury will be severe and cause everlasting damage.
Heel bulbs are the region that most typically gets injured by overreaching. The heel bulb is the fleshy part of the rear section of a horse’s foot – proper above their hairline and under their pasterns.
A horse’s rear hoof can strike the heel bulb with such a force that it cuts through flesh and severely injure your horse, inflicting pain, swelling, and profuse bleeding. In some cases, horses develop lengthy-lasting problems and lameness.
Essentially the most critical injuries occur when a horse strikes into the back of its pastern. Higher up overreach accidents on the back of their leg might also find yourself with them in surgery as a consequence of lacerating tendons or going into tendon sheath just above the fetlock area.
How do horses wear bell boots?
There are two major types of bell boots, pull-on and open bell boots with velcro closures. Pull-on boots are typically made of rubber and slide over your horse’s foot. They're simple to clean and great for horses who need boots during flip-out and often get their toes wet.
Fitting pull-on bell boots
Pull-on bell boots shouldn’t fit snug on your horse’s pastern but somewhat be loose. If they are tight, they'll irritate the horse skin and rub it raw. To help prevent chafing, some bell boots are fleece lined, which is nice however fitting your boots correctly is still important.
Ideally, you need to be able to fit a finger between the top of the bell boot and your horse’s lower leg. However it's best to only be able to fit one finger because if the boots are too giant, they will slide off your horse’s foot. When your horse is standing on a flat surface, the back of the boot should almost touch the ground.
Most bell boots are available in four sizes: small, medium, large, and additional-large. Typically Arabians and Quarter horses use medium, Thoroughbreds giant, and additional-massive fit Warmbloods. There's quite a lot of variation in manufacturer sizing, so it’s best to be safe and read evaluations earlier than buying.
Putting pull-on bell boots on your horse.
Placing pull-on bell boots on your horse isn’t always easy and takes some practice. First, turn the bell boot inside out. Then lift your horse’s foot and put the bell boot on, starting on the bottom of it.
As you set it on, pull hard to stretch it, work your way up to where it is smaller, and then tug on it till you may fit your horse’s hoof through. Once it’s on, flip it down, and the boot is ready.
Flexible bell boots that stretch easily work finest to get the best fit and are easier to get over the horse’s hoof.
Putting on open bell boots
Placing on open bell boots in your horse is easy. You just wrap them around the horse’s hoof and then secure them with velcro straps. Some have a hook-and-loop closure so you possibly can adjust to fit different measurement feet.
Bell boots designed with velcro straps are typically more costly, however they save you time getting them on and off, and most are made of sturdier material than their pull-on counterparts.
How do you know if your horse wants bell boots?
A straightforward way to know in case your horse would benefit from wearing bell boots is that if they arrive back from working with scrapes or swelling on its heels. One other thing to look for is if they're consistently losing shoes or often have loose shoes.
Bell boots help protect the shoes in your horse’s entrance ft from being pulled off once they’re hit by their back foot. This is widespread amongst some horses which have been turned out to play or ones running fast, however it can occur throughout different activities too!
For those who have just about any issues about where and also how you can use bell boots horses, you are able to e-mail us on our own page.
Forum Role: Participant
Topics Started: 0
Replies Created: 0